Technical Information - Autotorch 2

Gas supply for Autotorch 2100

For use at high pressure (0.35-2bar).

Cylinders

Any standard propane regulator with a screwed connection.

Any of the Tinyregs or Bijou regulators. The No.1051/11 variable Tinyreg for propane is recommended to give the best results from this torch.

Hose

Any of the Tinyregs or Bijou regulators. The No.1051 variable Tinyreg for propane is recommended to give the best results from these torches.

Hose

4.8mm high pressure hose to BS.3212/2 (no.1299) only must be used, with suitable hose clips.

Flashback Arrestors

Flashback arrestors are not needed for these torches

To check the spark

Turn off the gas using the valve with the screw down knob and disconnect the burner. Find a piece of metal to bridge the gap between the burner connection on the handle and the spark point on the hande. Rest the metal on the connection and a few millimetre from the spark point and and push the red button a few times to see if there is a spark. See video by clicking here: Check spark